Allegedly leaked information and photos on the PilotsofAmerica.com forum. Very interesting stuff here if it’s confirmed.
At about 700 ft AGL, the auto throttle commanded engine acceleration. One engine started to rollback during and the other engine started to accelerate then 8-10 seconds later began to roll back. Once the flight crew noticed, they pushed the throttles up and the engines’ EECs responded but the engines did not. It appears that no fuel was getting to the engines.
The investigation continues to look broadly for a cause of the dual engine rollbacks. Fuel exhaustion is the only item that has been positively ruled out. Aspects that the FAA believes the investigation is concentrating on are:
• Ice in the fuel somehow limiting the fuel flow to the engines. A maintenance message indicating excessive water in the center tank was set during taxi on the two previous flight legs, although it cleared itself both times. The airplane was being operated in a high humidity, cold environment, conducive to ice formation.
• Small-sized contamination building up in the engine fuel systems somehow limited the fuel flow to engine. All the fuel samples have tested for contamination of larger particles (sizes outside the fuel specification). Testing has been started looking for small particles (greater than 5 microns).
• Engine hardware failures sending inaccurate data to the engine electronic control (EEC) causing the EEC to demand insufficient fuel. A preliminary review of the EEC data from the right engine shows erratic combustor inlet pressure (P30). A leaking P30 sense line could cause this, or the EEC receiving a higher than actual fuel flow parameter.
• Software coding problem in the EEC causing the EEC to demand insufficient fuel. British Airways installed a new engine EEC software revision in December 2007. The software was approved in May 2006. There were several changes to the software as part of the revision. Two items seem remotely related to the accident: improvements to low power stall recovery logic and fan keep out zones for ground maintenance. The first two items would be related to a part 25 compliance issue, while the last two items would be related to a part 33 compliance issue.
MUCH MORE BELOW THE FOLD
This post was originally published to the internet between 2007 and 2012. Links, images, and embedded media from that era may no longer function as intended.
This post originally appeared at Flightglobal.com from 2007 to 2012.